E 350 V10-6.8L (2007)
Fluid - A/T: Testing and Inspection
Torqshift Automatic Transmission
Check Fluid Level and Condition
Fluid Level Check
CAUTION: The vehicle should not be driven if the fluid level indicator shows the fluid below the DO NOT DRIVE mark or internal failure
could result.
NOTE: If the vehicle has been operated for an extended period of time at highway speeds, in city traffic, in hot weather, or while pulling a trailer, the
fluid needs to cool down to obtain an accurate reading.
NOTE: The fluid level reading on the indicator will differ depending on operating and ambient temperatures. The correct reading should be within
the normal operating temperature range.
NOTE: Automatic transmission fluid (ATF) may be checked in the cold temperature range if the ambient temperature is between 10° - 32°C (50° -
90°F). Checking the ATF level using the cold range will indicate that the vehicle has sufficient transmission fluid to be driven. Adding fluid using the
cold range may result in an overflow condition when the vehicle reaches normal operating temperature. Fluid level must be checked while in the
normal operating range of 66° - 77°C (150° - 170°F) to make sure that the fluid level is accurately checked and fluid level adjusted correctly.
Under normal circumstances the fluid level should be checked during normal maintenance. If the transmission starts to slip, shifts slowly or shows
signs of leaking, the fluid level should be checked.
1. Drive the vehicle 32 km (20 miles) or until the vehicle reaches normal operating temperature.
2. Park the vehicle on a level surface and apply the parking brake.
3. With the parking brake applied and your foot on the brake pedal, start the engine and move the range selector lever through all the gear ranges.
Allow sufficient time for each gear to engage.
4. Place the range selector lever in PARK and leave the engine running.
5. Remove the fluid level indicator and wipe it clean with a lint free cloth.
6. Install the fluid level indicator until it is fully seated into the filler tube.
7. Remove the fluid level indicator and inspect the fluid level. The fluid level should be in the designated are for normal and room temperature.
Blade Design Fluid Level Indicator Used on Some Applications
