E 350 V10-6.8L (2007)
^
Tighten the ground cable to 20 Nm (15 ft. lbs.)
^
Tighten the battery cable to 12 Nm (9 ft. lbs.)
^
Tighten solenoid wire to 6 Nm (53 inch lbs.)
5. Install the starter motor solenoid terminal cover.
6. Connect the transmission cooler tubes onto the rear bracket.
7. Install the transmission cooler tubes and starter motor electrical harness front bracket and nut.
^
Tighten to 12 Nm (9 ft. lbs.)
8. Connect the battery ground cable. For additional information, refer to Battery.
9. Connect the transmission fluid cooler hose.
