E 350 V10-6.8L (2007)
Manual Control Lever Shaft and Seal
Special Tool(s)
Material
Removal and Installation
CAUTION: Use care not to damage the manual control lever shaft bore. The new seal can leak.
CAUTION: Discard the outer manual control lever nut.
NOTE: When removing the manual control lever shaft retaining pin, use a soft cloth to protect the surface of the case.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Loosen, but do not remove the transmission fluid pan bolts and allow the fluid to drain. Once the fluid has drained, remove the bolts.
3. Remove the transmission fluid pan and gasket.