E 350 V10-6.8L (2007)
4. NOTE: Depending on the paint markings, there are 2 methods of indexing the driveshaft and the output shaft.
Install the driveshaft.
1
Preferred method - align the factory-made paint marks on the output shaft and driveshaft and position the driveshaft in the transmission.
2
Alternate method - align the index marks and position the driveshaft in the transmission.
5. CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply sealer to the threads of the original bolts.
CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange,
tighten the bolts evenly in a cross pattern in the sequence shown.
Position the driveshaft flange yoke on the pinion flange with the index marks aligned and install the driveshaft-to-pinion flange bolts.