E 350 V10-6.8L (2007)
Installation
1. Using the special tools 205-098, 205-100 and 205-278, install the inner and outer bearing cups.
^
Check to determine if a 0.038 mm (0.0015 inch) feeler gauge can be inserted between the cups and the rear hub at any point around each cup.
Reseat the bearing cups, if necessary.
2. Install the inner rear wheel bearing in the rear hub.
3. Install a new rear hub seal.
^
Use a suitable seal installer.
4. Position the rear brake disc on the rear hub and install the bolts.
^
Tighten to 104 Nm (77 ft. lbs.)