E 350 V10-6.8L (2007)
9. Cut the urethane applicator tip to specification.
10. NOTE: Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
Apply a bead of Urethane Adhesive to the cleaned area.
11. NOTE: Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Backfill the urethane application and clean the excess.
12. CAUTION: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as
necessary.
13. Install the interior rear view mirror.
14. Install the sun visors.
15. If equipped, install the dome lamp assembly.
16. If equipped, install the overhead console.
17. Install the A-pillar trim panels.
18. Install the cowl top vent panel.
19. Install the windshield wiper pivot arms.
20. Clean the exterior and interior of the windshield glass with glass cleaner.
