E 350 V10-6.8L VIN S (2006)
Rear Wheel Speed Sensor - Traction Control and Stability Assist
Rear Wheel Speed Sensor - Traction Control and Stability Assist
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the wheel speed sensor electrical connector.
3. Disconnect the wheel speed sensor harness clips.
4. Remove the rear wheel speed sensor bolt, spacer and the sensor.
^
To install, tighten to 25 Nm (18 ft. lbs.).
5. To install, reverse the removal procedure.
