E 350 V10-6.8L VIN S (2006)
Accumulator HVAC: Service and Repair
SUCTION ACCUMULATOR
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant.
2. Disconnect the battery.
3. Remove the battery.
4. Remove the battery tray.
1
Remove the bolts.
2
Remove the battery tray.
-
To install, tighten to 28 Nm (21 lb-ft).
5. Position the washer reservoir filler tube aside.
1
Remove the screws.
2
Position the washer reservoir filler tube aside.
6. CAUTION: Use a wrench on each side of the fitting to prevent twisting of the refrigerant line.
Disconnect the evaporator outlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 39 Nm (29 lb-ft).