E 350 V10-6.8L VIN S (2006)
Remote Fluid Filter
NOTE: The remote filter for this vehicle is located on the LH side of the transmission.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the remote filter housing by unscrewing it.
3. Remove the spring/retainer and magnet assembly.
4. Remove and discard the remote filter element.
Install
1. Inspect the O-ring for damage (nicks or cuts).
Install a new O-ring if damage is indicated.
2. Install a new remote filter element.
3. Clean the spring/retainer and magnet assembly and install it into the remote filter element.
4. Clean the remote filter housing and install.
^
Tighten to 50 Nm (37 ft. lbs.).
5. Fill with clean automatic transmission fluid.
Fluid Pan, Gasket and Filter
Fluid Pan, Gasket and Filter
