E 350 V10-6.8L VIN S (2006)
failure.
Open the air cleaner.
-
Release the air box clamp.
-
Separate the inlet side from the outlet side of the air cleaner.
4. Release the latches and remove the MAF assembly.
5. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the MAF sensor electrical connector.
6. Remove the screws and MAF sensor.
-
To install, tighten to 2 Nm (18 lb-in).
7. CAUTION: The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will
result in unmetered air entering the engine.
NOTE: Use the alignment notch to correctly align the inlet side and the outlet side of the engine air cleaner.
To install, reverse the removal procedure.
