E 350 V10-6.8L VIN S (2006)
Power Steering Fluid Cooler: Service and Repair
Power Steering Fluid Cooler
Material
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can occur.
1. Remove the transmission fluid cooler.
2. Compress the clamp and disconnect the steering gear-to-fluid cooler return hose from the cooler.
3. Compress the clamp and disconnect the power steering cooler-to-reservoir hose from the cooler.
4. Remove the 2 power steering cooler bolts and the power steering cooler.
^
To install, tighten to 11 Nm (8 ft. lbs.).
5. To install, reverse the removal procedure.
^
Fill and leak check the system.