E 350 V10-6.8L VIN S (2006)
4. With the vehicle in NEUTRAL, position it on a hoist.
5. Remove and discard the drag link cotter pin and nut.
^
To install, tighten to 92 Nm (68 ft. lbs.).
6. Using the special tool, separate the drag link.
7. Remove the 3 power steering gear bolts and the gear.
^
To install, tighten to 81 Nm (60 ft. lbs.).
8. Secure the steering gear in a vise and remove the nut and lockwasher.
^
To install, tighten to 270 Nm (199 ft. lbs.).
9. Using the special tool, remove the steering gear sector shaft arm.
10. NOTE: When connecting a fitting with an O-ring seal, a new seal must be installed.
To install, reverse the removal procedure.
^
Using the special tool, install new O-ring seals on the power steering line fittings.
^
Fill and leak check the system.
