E 350 V8-4.6L SOHC VIN W (2005)
Power Seat Switch: Service and Repair
SEAT CONTROL SWITCH
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
The belt and buckle assembly pretensioner is a pyrotechnic device. Never probe the connectors on the belt and buckle assembly
pretensioner. Doing so can result in belt and buckle assembly pretensioner or air bag deployment and can result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS. See: Restraint Systems/Air Bag Systems/Service and Repair
2. Remove the screw from behind the seat back latch handle.
3. Remove the front seat back latch lower cover screw from the front of the seat.