E 350 V8-4.6L SOHC VIN W (2005)
Parking Brake Control: Service and Repair
Parking Brake Control
Removal and Installation
All vehicles except E-450
1. Relieve the tension on the parking brake system.
1
Pull down on the parking brake intermediate cable.
2
Insert a 4 mm (0.16 inch) drill bit or equivalent retainer in the parking brake control.
E-450
2. NOTE: Make sure the parking brake is fully released.
With the transmission in NEUTRAL, position the vehicle on a hoist.
3. Disconnect the front parking brake cable and conduit from the parking brake lever.
^
Remove the locking pin from the clevis pin and remove the clevis pin.
All vehicles
4. Lower the vehicle.
5. Remove the LH cowl side trim panel.