E 350 V8-4.6L SOHC VIN W (2005)
gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future oil leakage.
Apply a bead of silicone gasket and sealant at the engine front cover-to-cylinder block surface, at the locations shown.
4. Tighten the bolts in three stages, in the sequence shown.
^
Stage 1: Tighten to 2 Nm (18 inch lbs.).
^
Stage 2: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 3: Tighten an additional 90 degrees.
5. Install a new oil filter.
6. Lower the engine and remove the special tools.
7. NOTE: RH shown; LH similar.
