E 350 V8-4.6L SOHC VIN W (2005)
1. NOTE: The EGR valve sealing surfaces are soft metals.
Carefully clean both sealing surfaces.
-
Install a new EGR system module gasket with the side with the raised ring facing the intake manifold.
2. Install the EGR system module and bolts.
-
Tighten the bolts in two stages.
-
Stage 1: Tighten to 20 Nm (15 lb-ft).
-
Stage 2: Tighten an additional 90 degrees.
3. Connect the EGR valve tube fitting and vacuum line.
4. Connect the EGR system module electrical connector.
-
Push in the red clip.