E 350 V8-4.6L SOHC VIN W (2005)
2. Mark the driveshaft flange and the pinion flange for correct alignment during installation.
3. Remove and discard the four bolts.
4. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear axle pinion flange.
^
Position the driveshaft out of the way.
5. Install a Nm (inch-pound) torque wrench on the pinion nut, and record the torque required to maintain rotation of the pinion through several
revolutions.
6. Remove the pinion flange and pinion nut.
^
Discard the pinion nut.