E 350 V8-5.4L (2008)
remove the seat, remove the seat latch striker with the seat attached.
Pull the 2 seat latch release straps and remove the rear seat.
3. Remove the seat cushion trim cover.
4. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
If equipped, remove the bolt and RH detachable safety belt anchor.
-
To install, tighten to 60 Nm (44 lb-ft).
5. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
If equipped, remove the bolt and LH detachable safety belt anchor (7-passenger vehicle).
-
To install, tighten to 60 Nm (44 lb-ft).
6. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
Remove the bolt and safety belt buckle.
-
Route through the seat cushion.
-
To install, tighten to 75 Nm (55 lb-ft).
7. Remove the cushion foam pad from the seat cushion frame.
8. NOTE: The anti-rotation tab(s) must be correctly aligned for correct installation.
If equipped, remove the 2 bolts and 2 lower anchors and tethers for children (LATCH) anchors.
-
If 5-passenger vehicle, remove the 4 bolts and 4 LATCH anchors.
-
To install, tighten to 51 Nm (38 lb-ft).
9. NOTE: The anti-rotation tab(s) must be correctly aligned for correct installation.
If equipped, remove the bolt(s) and child safety seat tether anchor(s).
-
To install, tighten to 25 Nm (18 lb-ft).
10. To assemble, reverse the disassembly procedure.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Verify the safety belt retractor operates without excessive effort or binding.
Seat Cushion - Rear, Bench, 4-Passenger
SEAT CUSHION - REAR, BENCH, 4-PASSENGER
