E 350 V8-5.4L (2008)
Housing Assembly HVAC: Service and Repair
Evaporator Core Housing
EVAPORATOR CORE HOUSING
Removal and Installation
1. Remove the heater core housing.
2. Remove the evaporator core.
3. Detach the wire harness.
1
Remove the nut and stud.
2
Disconnect the electrical connector and position the wire harness aside.
4. Remove the 2 suction accumulator bolts and the suction accumulator.
-
To install, tighten to 14 Nm (10 lb-ft).
5. Remove the washer reservoir.
1
Remove the nut.
2
Remove the bolt.
3
Remove the washer reservoir.
-
Disconnect the washer pump hose and electrical connector.
6. Disconnect the blower motor electrical connector.
