E 350 V8-5.4L (2008)
Van/wagon vehicles
6. Remove the heat shield bolt.
-
To install, tighten to 18 Nm (13 lb-ft).
7. Remove the lower EVAP canister and bracket assembly bolts and the heat shield.
-
To install, tighten to 18 Nm (13 lb-ft).
All vehicles
8. NOTE: Van/wagon vehicle lower EVAP canister and bracket assembly bolts will already be removed.
Remove the EVAP canister and bracket assembly bolts and remove the EVAP canister and bracket assembly from the vehicle.
-
To install, tighten to 18 Nm (13 lb-ft).
9. Disconnect the EVAP canister vent solenoid-to-dust separator hose and remove the dust separator from the EVAP canister bracket.
10. NOTE: Lubricate the O-ring seals with clean engine oil.
To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Powertrain Management/Emission Control Systems/Evaporative Emissions
System/Testing and Inspection
-
Carry out the evaporative emission repair verification drive cycle.
