E 350 V8-5.4L (2008)
9. Disconnect the TSS and intermediate shaft combination speed sensor electrical connector.
10. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the
transmission.
Remove the TSS and intermediate shaft combination speed sensor.
1) Remove the bolt.
2) Remove the TSS and intermediate shaft combination speed sensor.
Installation
1. Install the TSS and intermediate shaft combination speed sensor.
1) Lubricate the O-ring with clean transmission fluid and install the TSS and intermediate shaft combination speed sensor.
2) Install the bolt.
^
Tighten to 9 Nm (80 lb-inch).
2. Connect the TSS and intermediate shaft combination speed sensor electrical connector.
