E 350 V8-6.0L DSL Turbo VIN P (2004)
Special Tool(s)
Material
Removal
1. Remove the tire and wheel assembly.
2. CAUTION: When the brake hose flow bolt is removed, plug the brake hose to minimize brake fluid loss and air entry.
Remove the brake hose flow bolt. Discard the copper washers.
3. Set the caliper locking pin drive-out.
1
Set the notched end of the Brake Caliper Pin Remover at a 45-degree angle against the end of the upper caliper locking pin.
2
Tap the tool to squeeze the caliper locking pin so the retention tabs can clear the support bracket.