E 350 V8-6.0L DSL Turbo VIN P (2004)
Housing Assembly HVAC: Service and Repair
Disassembly and Assembly
PLENUM CHAMBER
DISASSEMBLY
1. Remove the plenum chamber.
2. Remove the floor/defrost door vacuum control motor.
1
Disconnect vacuum lines.
2
Remove the screws.
3
Lift the vacuum control motor off the mode door pivot shaft.
4
Remove the vacuum control motor.
3. Remove the panel door vacuum control motor.
1
Disconnect the vacuum line.
2
Remove the screws.
3
Lift the vacuum control motor off the mode door pivot shaft.
4
Remove the vacuum control motor.
4. Remove the vacuum lines.
ASSEMBLY
1. To assemble, reverse the disassembly procedure.