E 350 V8-6.0L DSL Turbo VIN P (2004)
Pressure Feedback Exhaust Sensor: Service and Repair
Exhaust Back Pressure Sensor
EXHAUST BACK PRESSURE SENSOR
REMOVAL
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Remove the engine cover.
3. Disconnect the exhaust back pressure (EBP) sensor electrical connector.
4. CAUTION: Use a backup wrench to remove the exhaust back pressure sensor.
Remove the EBP sensor.
INSTALLATION
1. To install, reverse the removal procedure.