E 350 V8-6.0L DSL Turbo VIN P (2004)
Air Bag: Technician Safety Information
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
-
Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event
of an accidental deployment.
-
Do not set a live air bag module down with the trim cover face down.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
Air bag modules with discolored or damaged trim covers must be replaced, not repainted.
-
Restraint system diagnostic tools are for service only. Tools must be removed prior to operating the vehicle over the road. Failure to
remove restraint system diagnostic tools could result in injury and possible violation of vehicle safety standards.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The front impact severity sensor is located behind the grille.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
-
To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the supplemental restraint
system (SRS) deactivation/reactivation procedure.
