E 350 V8-6.0L DSL Turbo VIN P (2004)
Power Steering Pump: Service and Repair
Pump Pulley
Power Steering Pump Pulley
Special Tool(s)
Removal and Installation
Vehicles with 6.0L engine
1. Remove the engine cooling fan.
All vehicles
2. Rotate the tensioner clockwise and remove the belt from the power steering pump pulley.
3. With the vehicle in NEUTRAL, position on a hoist.
4. If equipped, remove the deflector shield.
5. NOTE: Make sure to install the power steering pump pulley until it is flush with the power steering pump shaft. Inspect the belt alignment
following installation to ensure correct alignment and prevent intermittent belt noise.
Using the special tool, remove the pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is no paint mark, use a