E 350 V8-6.0L DSL Turbo VIN P (2004)
C.
Make two 1.5-meter (5-foot) vertical marks (using masking tape) on the wall or screen at the same distance from the center line as recorded
in Step B. See Figure 5.
7.
On the wall or screen, locate the high intensity area of the beam pattern. Place the left edge of the high intensity zone even with the vertical line
corresponding to the headlamp being adjusted.
SUPPLEMENTAL SAFETY CERTIFICATION LABEL INSTALLATION
1.
Locate and clean the area above the safety certification label on the driver's doorjamb. DO NOT remove the original label.
2.
Install the new supplemental label on the vehicle above the existing label as shown in Figure 6.
