E 350 V8-6.0L DSL Turbo VIN P (2004)
Transmission Mount: Service and Repair
4R100 Automatic Transmission
Transmission Insulator and Retainer
Special Tool(s)
Removal
1. Raise and support the vehicle.
2. Remove the nuts.
3. Install the high-lift transmission jack with the special tool to the transmission.
4. CAUTION: Be sure not to raise the back of the transmission too high, if it makes contact with the underbody, damage to the turbine shaft speed
(TSS) and output shaft speed (OSS) sensors will occur.
Remove the rear transmission mount.
1. Raise the transmission up off the rear crossmember support.
2. Remove the bolts.
