E 350 1 Ton Van V10-6.8L VIN S (1997)
5. Make sure the tightening has caused the cinch strap to slip the minimum specified length from the length recorded in Step 3. If the cinch strap has
not slipped the specified amount, tighten the tension limiter nut the additional amount necessary to achieve the specified slippage.
NOTE: The tension limiter will reset the parking brake tension any time the system is disconnected, provided the distance between the bracket
and the cinch strap hook is reduced during adjustment. When the cinch strap hook contacts the bracket, the tension limiter must be replaced to
prevent overtensioning.
6. Release the parking brake control.
7. Depress to the floor and release the parking brake control two times.
8. Test the parking brake.
a. Apply the parking brake. The parking brake cables must be tight enough to provide full application of the rear brake shoes and linings.
b. Release the parking brake. The parking cables must be loose enough so that there is no drag at the rear wheels.
