E 350 1 Ton Van V10-6.8L VIN S (1997)
Camshaft Gear/Sprocket: Service and Repair
Removal
WARNING: DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR
ANY FUEL-RELATED COMPONENTS. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND CAN BE IGNITED,
RESULTING IN POSSIBLE PERSONAL INJURY. FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN
THE ENGINE IS NOT RUNNING.
1. Disconnect the battery ground cable.
2. Remove the cam covers.
3. Remove the radiator.
4. Disconnect the camshaft position sensor.
5. Remove the water pump.
6. Raise and support the vehicle.
7. Remove the power steering pump bolts and position the power steering pump aside.
NOTE: Only three bolts are required to secure the power steering pump.
8. Disconnect the crankshaft position (CKP) sensor electrical connector.
9. Remove the drain plug and drain the engine oil.
10. Remove the crankshaft front seal.