E 350 1 Ton Van V10-6.8L VIN S (1997)
2.
Locate the blue CMS wiring harness connector that is located on the left frame rail or the crossmember and then remove the plug from the end of
the connector. See Figure 5.
3.
Install the new CMS wiring harness.
^
For the 138" wheelbase vehicle, connect one end of the new harness to the blue CMS wiring harness connector. Route the harness across the
front of the crossmember to the right-hand frame rail. At the right-hand frame rail, route the harness over the top of the crossmember, down the
bottom edge of the frame rail and connect the harness to the CMS.
^
For the 158" wheelbase vehicle, connect on end of the new harness to the blue CMS wiring harness connector. Route the harness across the
front of the crossmember to the right-hand frame rail. At the right-hand frame rail, route the harness over the top of the crossmember and
connect the harness to the CMS.
