E 350 1 Ton Van V10-6.8L VIN S (1997)
8. Install the coast clutch pressure plate retainer snap ring.
9. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct coast clutch pressure plate retainer snap ring and recheck the clearance.
10. Install the overdrive sun gear, with the short end of the gear downward.
Center Support
DISASSEMBLY
1. Using the (A) O-Ring Tool, remove and discard the (B) direct clutch seal rings. Remove the (C) No. 6 center support thrust washer.
