E 350 1 Ton Van V10-6.8L VIN S (1997)
10. Install the No. 5 overdrive center shaft thrust bearing assembly.
NOTE: Lightly lubricate the thrust bearing with petroleum jelly to hold it in place during assembly. The inner bearing race lip must face upward.
11. Install the overdrive center shaft assembly.
(1) Remove the (A) selective coast clutch pressure plate retainer snap ring, the (B) coast clutch pressure plate and the (C) clutch plates from the
(D) coast clutch cylinder.
(2) Install the (E) overdrive center shaft assembly into the (D) coast clutch cylinder.
(3) Reinstall the (C) clutch plates, the (B) coast clutch pressure plate and the (A) selective coast clutch pressure plate retainer snap ring into the
(D) coast clutch cylinder.
