E 350 1 Ton Van V10-6.8L VIN S (1997)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise and support the vehicle.
2. Remove the driveshaft.
3. With a suitable drain pan properly positioned, remove the (A) extension housing seal, using the (B) Seal Remover and the (C) Impact Slide
Hammer.
4. Using the (A) Extension Housing Bushing Remover, remove the (B) extension housing bushing.
CAUTION: Do not damage any machined surfaces.
INSTALLATION
1. Align the extension housing bushing in the extension housing so that the slots are in the 2 o,clock and 7 o,clock positions.
CAUTION: Prior to installing the extension housing bushing, inspect the extension housing counterbore for burrs. If necessary, remove the burrs
with an oil stone.
