E 350 Van L6-300 4.9L VIN E 1-bbl (1982)
Figure 22
Drain Tube Replacement (Refer to Figure 22)
1.
Pull the aspirator air hose from the aspirator outlet drain tube assembly.
2.
Remove the aspirator outlet drain tube assembly from the barbed connection of the plastic evaporator drain tube projecting inboard from the
bottom of the housing.
3.
Remove the plastic evaporator drain tube and seal attached to the bottom of the evaporator housing by removing the two attaching screws with a
5/16 inch socket. Replace existing drain tube with E5UZ-19858-B drain assembly shown in Figure 22. Apply silicone sealer to the seal surface to
insure a complete seal. Install seal, drain tube and attaching screws.
4.
Plug aspirator air hose with rubber cap 382443-S or similar and tape hose out of the way on the underside of evaporator housing.
Econoline Vehicles With "Duck Bill" Drain Tube Built Prior to March, 1984
