E 350 Van L6-300 4.9L VIN E 1-bbl (1982)
Figure 32
Figure 33
9.
Install the deflector (E7UZ-19B898-A) in the evaporator housing by applying RTV sealant to the deflector flange, inserting it through the door
opening, aligning it with the evaporator face and the door assembly and then firmly pressing the flange against the evaporator case floor until the
sealant sets. See Figures 31 and 33.
10.
Apply sealant to the flange of the venturi tube (E7UZ-18K368-A) and insert the tube through the hole made in Step 4. See Figure 33. Ensure that
the tube end is aligned with the hole made in Step 7. Verify that a 1/8 inch gap exists between the bottom of the tube end and the housing wall for
trapped condensate to exit. See Figure 33. If required, slot the screw hole.
