E 350 Van L6-300 4.9L VIN E 1-bbl (1982)
Spindle Bushing Service
4. Remove and install the top spindle bushing first. Install the driver handle through the bottom bore. Position a new bushing on the "T" side
stamping of the bushing Remover/Installer Driver. The bushing must be installed on the tool so the open end grooves will face outward when
installed. Position the new bushing and driver over the old bushing, insert the handle into the driver and drive the old bushing out while the new
bushing is driven in. Drive until the tool is seated. The bushing will then be seated at the proper depth (2.03 mm [0.080 inch)] minimum from
bottom of upper spindle boss).
Spindle Bushing Service
5. Remove and install the bottom spindle bushing. Install the Driver Handle through the top bushing bore. Position a new bushing on the "B" side
stamping of the Bushing Remover/Installer Driver. The bushing must be installed on the tool so the open-end grooves will face outward when
installed. Position the new bushing and driver over the old bushing in the bottom spindle bore. Insert the handle into the driver and drive the old
bushing out while the new bushing is driven in. Drive until the tool is seated. The bottom bushing will then be seated at the proper depth (3.30 mm
[0.130 inch] minimum from the top of the lower spindle boss).
