E 350 Van L6-300 4.9L VIN E 1-bbl (1982)
Spindle Bushing Service
6. Ream the new bushings to 0.025-0.076 mm (0.001-0.003 inch) larger than the diameter of a new spindle pin. Ream the top bushing first with the
reamer tool. Install the smaller diameter of the tool through the top bore and into the bottom bore until the reaming threads are in position in the
top bushing. Turn the tool until the threads exit the top bushing. Ream the bottom bushing. The larger diameter portion of the tool will act as a
pilot in the top bushing to properly ream the bottom bushing.
7. Clean all the metal shavings from the bronze bushings after reaming. Coat the bushings and spindle pin with Long Life Lubricant,
C1AZ-19590-BA (ESA-M1C75-B) or equivalent.
8. Install a new seal on Bushing Remover/Installer Driver tool on the side with the "T" stamping. Install the handle into the driver and push the seal
into position in the bottom of the top bushing bore.
INSTALL
1. Reverse removal procedure to install.
