E 350 Van V8-351 5.8L VIN G 2-bbl (1985)
NOTE:
Route this hose so that it is elevated above the PCV hose (minimum six (6) inches) to prevent possible fuel/oil migration to the
compensator assembly.
FIGURE 2
7.
Install a 3/16" plastic tee (Item 4) and the 1.0" length of 3/16" vacuum hose (Item 9) into the open end of the EGR vacuum line (white
plastic) and connect the 3/16" vacuum hose to the carburetor EGR port. (See Figure 2).
8.
Route the 3/16" vacuum hose (green stripe) from the altitude compensator vacuum valve (black) to the plastic tee installed in the EGR
vacuum hose. Cut hose to required length.
9.
Locate the intake manifold vacuum fitting (tree) at the rear of the intake manifold. Install a 1/4-3/16 vacuum tee (Item 5) in the 1/4" vacuum
line connected to the intake manifold tree. Cut the 1/4" vacuum hose at a convenient location and insert the vacuum tee.
10.
Locate the 3/16" vacuum hose (red stripe) from the altitude compensator vacuum/electric switch and route this hose behind the battery and in
front of the heat housing. Then route the hose under the thermactor outlet hoses around distributor (front or rear) to the 1/4-3/16 vacuum tee
installed in step 9.
NOTE:
Route and secure the hose near the front of the heater housing to avoid the hose being pinched when installing battery in step 13.
11.
Ground the altitude compensator assembly (black wire) to a suitable body location. Cut the wire to the required length, attach the ring tongue
terminal. (Item 8 provided in the kit) (See Figure 2).
