E 350 Van V8-7.3L DSL (1988)
Figure 1
REMOVAL
1. Remove the TPS button head torx cap screws and washers by using a T-27 x 2 inch torx bit, Figure 1. This bit is usually used for the face cam screw.
CAUTION:
DO NOT REMOVE THE SCREWS THAT MOUNT THE SENSOR TO THE BRACKET.
2. Position the throttle lever in the wide open position.
3. Remove the small set screw located at the 5:00 o'clock position.
4. Remove the large set screw located at the 2:00 o'clock position.
5. Slide the shaft adapter off the pump throttle lever shaft.
INSTALLATION
1. Position the throttle lever in the wide open position.
2. Slide the shaft adapter onto the throttle lever shaft with the small set screw hole directed to the 5:00 o'clock position.
a. Insert a small pointed tool, such as a dental pic into the small 5:00 o'clock hole.
b. Move the shaft adapter until the hole on the throttle lever shaft is located with the tool.
3. Install the large set screw at the 2:00 o'clock position. Tighten to 30 lb.in. (3.4 N-m). Remove the tool.
4. Install the small set screw at the 5:00 o'clock position. Tighten to 30 lb.in. (3.4 N-m).
5. Install the TPS button head torx cap screws and washers by using a T-27 x 2 inch torx bit.
OTHER APPLICABLE ARTICLES: 89-12-8
WARRANTY STATUS:
Eligible Under Basic Warranty Coverage, Powertrain Warranty Coverage
OPERATION
DESCRIPTION
TIME
900209A
Remove TPS Sensor
0.4 Hr.
DEALER CODING
BASIC PART NO. CONDITION CODE
9B989
07
OASIS CODES:
4500
