E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Front Speed Sensor Ring Installation
2. Position new speed sensor ring on hub. Using a cylinder with 98mm (3.9 inch) ID and 106mm (4.2 inch) OD, press the ring on to the hub. The ring
must be fully seated against the shoulder in the hub.
3. Install hub, rotor and caliper assemblies.
4. Install wheel and tire assembly. Tighten wheel lugnuts to 115-142 Nm (85-105 ft lb).
Rear
INSPECTION
1. Remove the sensor.
2. View the speed sensor ring teeth through the sensor hole. Rotate the rear axle and check the speed sensor ring teeth for damage or breakage.
Dented or broken teeth could cause the ABS system to function when not required.
REMOVAL
To service the speed sensor ring, the differential case must be removed from the axle housing, and the speed sensor ring pressed off the case. Upon
removal, the speed sensor ring is to be discarded. It is not to be reused.
Rear Antilock Brake System (RABS)
INSPECTION
1. Remove the sensor.
2. View the speed sensor ring teeth through the sensor hole. Rotate the rear axle and check the speed sensor ring teeth for damage or breakage.
Dented or broken teeth could cause the ABS system to function when not required.
REMOVAL
To service the speed sensor ring, the differential case must be removed from the axle housing, and the speed sensor ring pressed off the case. Upon
removal, the speed sensor ring is to be discarded. It is not to be reused.
