E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Brake Hose/Line: Service and Repair
Service Procedure
Steel tubing is used in the hydraulic lines between the brake master cylinder and the front brake tube connector and between the rear brake tube
connector and the rear wheel cylinders. Steel tubing is also used to connect the brake master cylinder to the rear brake hose at the rear axle. Flexible
hoses connect the brake tube to the disc brake calipers and to the rear brake tube connector.
When replacing hydraulic brake tubing, hoses, or connectors, tighten all connections securely. After replacement, bleed the brake system at the rear
wheel cylinders and at the brake master cylinder. Refer to Brake Bleeding.
Rear Brake Tube Hose Connector
WARNING: Copper tubing should not be used in the hydraulic system. Use only sae J526 or J527 steel tubing, or equivalent.
NOTE: If a section of the brake tube is damaged, Replace the entire section with tubing of the same type, size, shape, and length. Be careful not to kink
or crack the tubing when bending it to fit the frame or rear-axle forms.
Double flare brake tubing as described below should provide good leakproof connections.
NOTE: Always clean the inside of a new brake tube with clean isopropyl alcohol.
