E 350 Van V8-7.3L DSL Turbo VIN F (1995)
2
--
Adjustment Screw
(Part of 2005)
A
--
24.89-25.27mm
(0.980-0.995 in.)
B
--
25.27mm (0.995 in.)
C
--
19.05mm (0.75 in.)
D
--
74.61mm (2.94 in.)
3. Position the brake master cylinder assembly over the booster push rod and onto the two studs on the power brake booster.
4. Install the attaching nuts and tighten 21-28 Nm (16-21 lb ft).
5. Loosely connect the rear brake master cylinder outlet tube and front brake master cylinder outlet tube to the brake master cylinder.
6. Tighten the rear outlet tube fitting to 15-20 Nm (11-14 lb ft) and the front outlet tube fitting to 21-28 Nm (16-21 lb ft).
7. Connect fluid level indicator switch.
8. Connect the battery ground cable.
9. Bleed the brake master cylinder. Refer to Brake Bleeding.
