E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve
REMOVAL
1. Disconnect the inlet and outlet brake lines from the RABS valve.
2. Disconnect the wiring harness from the RABS valve.
3. Remove the three screws retaining the RABS valve to the frame rail liner and remove the RABS valve.
INSTALLATION
1. Position the RABS valve on the frame side rail. Install the three screws and tighten to 26-32 N-m (19-24 lb-ft).
2. Connect the wiring harness connector to the RABS valve.
3. Connect the brake lines to the RABS valve and tighten as follows:
a. 1/2-20 threaded fitting -- 14-23 Nm (10-17 lb ft).
b. 7/16-24 threaded fitting -- 14-20 Nm (10-15 lb ft).
CAUTION: Do not overtighten the fittings.
4. Perform system brake bleeding procedure.
NOTE: It is not necessary to energize the RABS valve electrically to bleed the rear brakes.
