E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Anti-Lock Brake System Module: Service and Repair
Rear Antilock Brake System (RABS)
REMOVAL AND INSTALLATION
Anti-Lock Electronic Control Unit
1. Remove the screws/washers that hold the antilock electronic control module to the instrument panel lower brace. Pull the antilock electronic
control module off the retainer clip assembly.
2. Disconnect the wiring harness from the antilock electronic control module by depressing the plastic tab on the connector and pulling the connector
off.
3. For installation, follow removal steps in reverse order, followed by a system check for proper operation. Tighten screws/washers to 2 Nm (18 lb
in)
