E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Water Pump: Service and Repair
REMOVAL
1. Partially drain the engine cooling system.
2. Remove the air cleaner housing assembly.
3. Remove the upper radiator hose clamps and upper radiator hose (8260).
4. Disconnect the radiator coolant recovery reservoir hose at radiator (8005).
5. Remove the fan and clutch assembly using Fan Clutch Nut Wrench T83T-6312-B and Fan Clutch Pulley Holder T94T-6312-AH. Set fan and
clutch assembly in fan shroud (8146).
NOTE: the fan clutch assembly has right-hand thread. Install by turning nut clockwise.
6. Remove the fan shroud screws.
7. Remove the fan shroud, and fan and clutch assembly.
8. Loosen the water pump pulley bolts.
9. Remove the drive belt (8620).
10. Remove the water pump pulley bolts and water pump pulley (8509).
11. Disconnect the engine coolant temperature sensor (ECT sensor) (12A648).
12. Disconnect the heater hose and clamp from water pump.
13. Disconnect the engine coolant temperature sensor electrical connector.
14. Remove the water pump inlet bolts and water pump inlet.
15. Remove water pump bolts.
16. Remove water pump and water pump housing gasket (8507).
17. Clean gasket surfaces.
Water Pump
INSTALLATION
1. Install the water pump and water pump housing gasket.
2. Install the water pump bolts, tighten bolts to 20 Nm (15 ft lb).
3. Install the water pump inlet and bolts, tighten bolts to 20 Nm (15 ft lb).
