E 350 Van V8-7.3L DSL Turbo VIN F (1995)
b. Place the rocker arm pedestal on the steel ball.
Rocker Arm Cutaway View
c. Snap the retaining clip over the rocker arm pedestal groove.
2. Lubricate the push rod ends with engine oil and install the push rod (copper end up).
CAUTION: Failure to follow the next step of this procedure could result in bent valves.
3. Rotate the engine until the mark on the crankshaft damper is at 11 O'clock to prevent valve damage when installing the intake rocker arm and
exhaust rocker arm.
4. Install the intake rocker arm or exhaust rocker arm.
5. Install the two rocker arm bolts. Tighten rocker arm bolts evenly to 27 Nm (20 ft lb).
6. Install the valve cover gasket.
Fuel Injector Connector
7. Connect the electrical connectors to the fuel injectors and glow plugs.
8. Install the valve cover and retaining bolts. Tighten bolts to 11 Nm (8 ft lb).
