E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Oil Pan: Customer Interest
Engine - Oil Pan Leak
Article No.
03-21-7
10/06/03
ENGINE - ENGINE OIL LEAK - 7.3L DIT - MANUAL
TRANSMISSION - TRANSMISSION COVER PLATE
RUBS ON ENGINE OIL PAN
FORD:
1994-1995 F SUPER DUTY, F-250, F-350
Article 95-14-12 is being republished in its entirety as part of a consolidated 7.3L diagnostic aid booklet.
ISSUE
The rear of the engine oil pan, near the crankshaft, may leak oil. This can be caused by the clutch dust cover plate, on the bottom of the manual
transmission, coming in contact with the engine oil pan and rubbing a hole through the pan.
ACTION
Install a new clutch dust cover plate and replace the oil pan. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
1.
Remove the Clutch Dust Cover Plate, referring to the appropriate year F-Series Service Manual, Section 08-01.
2.
Inspect the rear of the oil pan near the crankshaft, looking for wear marks on the pan.
3.
If the wear mark(s) on the oil pan has evidence of oil leaks (crack or hole), replace the Engine Oil Pan Assembly (F4TZ-6675-AAA). Refer to the
appropriate year 7.3L Turbo Diesel Service Manual Supplement, Section 03-01D, for service procedures. If the wear mark on the oil pan has no
evidence of oil leaking, continue with diagnosis of customer concern over oil leaking. Proceed to Step 4.
4.
Install the redesigned Clutch Dust Cover Plate (F5TZ-7007-AD) and visually check to see that the edge of the plate is not rubbing the oil pan.
PARTS BLOCK
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 95-14-12
WARRANTY STATUS: INFORMATION ONLY
Disclaimer