E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Oil Pump Screen Cover
6. Remove the oil pump screen cover and tube.
7. Clean the oil pan mating surfaces and the oil pump screen cover and tube mating surfaces.
8. Inspect the oil pan and the oil pump screen cover and tube for damage.
CAUTION: Do not apply excessive amounts of RTV that could enter Into the oil lubrication system end cause a restriction.
INSTALLATION
1. Install oil pump inlet tube gasket (8626) on oil pump screen cover and tube mounting flange. Use a small amount of RTV Sealant to hold oil pump
inlet tube gasket in place if necessary.
2. Install the oil pump screen cover and tube to the engine front cover and crankshaft main bearing cap stud.
3. Install the oil pump screen cover and tube retaining screws finger-tight.
4. Install the oil pump screen cover and tube retaining nut.
5. Tighten the oil pump screen cover and tube retaining screws to 24 Nm (18 ft lb).
CAUTION: Do not apply excessive amounts of RTV that could enter into the oil lubrication system and cause a restriction.
NOTE: Install oil pan and retaining bolts within 10 minutes of applying RTV sealant.
Oil Pan Sealant Application
6. Apply a 3.2mm (1/8 in) bead of Silicone Rubber D6AZ-19562-BA or equivalent meeting Ford specification ESE-M4G195-A ESB-M4G92-A to
the crankcase oil Pan flange on the inside of the oil pan bolt holes.
7. Apply a 6.35mm (1/4 in) bead of Silicone Rubber D6AZ-19562-BA or equivalent meeting Ford specification ESE-M4G195-A or ESB-4G92-A to
the engine front and engine rear cover flange.
