E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Blower Motor Resistor: Service and Repair
Rear Air Blower Switch Resistor
REMOVAL AND INSTALLATION
1. Remove the third, fourth and fifth bench seats (if equipped).
2. Remove the left center bolster trim panel, left lower front trim panel. left rear lower and upper trim panels (if equipped).
3. Disconnect the electrical connector.
4. Remove the mounting screws and remove the heater blower motor switch resistor (18591)
5. For installation, follow removal procedures in reverse order. Check blower motor operation prior to installing trim.
